Thetford 40538 SmartTotes Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Thetford 40538 SmartTotes. Thetford 40538 SmartTotes User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 3
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Before Beginning
4 Read all instructions com-
pletely.
4Wear protective gloves,
glasses, long sleeves, and
nose/face mask to avoid con-
tact with human waste.
4For hygienic reasons, rinse
tank and hose thoroughly.
SmartTote
®
AutoStop
TM
Level Gauge
Kit
Made in the USA
Thetford Corporation
Ann Arbor, MI 1-800-521-3032 www.thetford.com
F# 40620 2/07
Part No.
40531
1. Pull old lanyard from tank
body.
2. Turn old Level Gauge clock-
wise until two finger tabs line
up with “O”s on tank body. Lift
off old Level Gauge. Discard.
3. Line up and insert new Level
Gauge into tank. Turn counter-
clockwise until finger tabs line
up with “V”s on tank.
4. Connect lanyard on tank.
Holding Tank Accessories
Before Beginning
4 Read all instructions com-
pletely.
4Wear protective gloves,
glasses, long sleeves, and
nose/face mask to avoid con-
tact with human waste.
4For hygienic reasons, rinse
tank and hose thoroughly.
SmartTote
®
AutoStop
TM
Level Gauge
Kit
Made in the USA
Thetford Corporation
Ann Arbor, MI 1-800-521-3032 www.thetford.com
F# 40620 2/07
Part No.
40531
1. Pull old lanyard from tank
body.
2. Turn old Level Gauge clock-
wise until two finger tabs line
up with “O”s on tank body. Lift
off old Level Gauge. Discard.
3. Line up and insert new Level
Gauge into tank. Turn counter-
clockwise until finger tabs line
up with “V”s on tank.
4. Connect lanyard on tank.
Holding Tank Accessories
Zobrazit stránku 0
1 2 3

Shrnutí obsahu

Strany 1 - Wear protective gloves

Before Beginning4 Read all instructions com-pletely.4Wear protective gloves, glasses, long sleeves, and nose/face mask to avoid con-tact with human w

Strany 2 - Hose Support

1. Place tank on one side.2. Remove two screws from Skid Plate. Slide Skid Plate down and pop it off of Axle Assembly. Set Skid Plate and screws asi

Strany 3 - Assembly

1. Place tank on one side.2. Remove two screws from Skid Plate. Slide Skid Plate down and pop it off of Axle Assembly. Set Skid Plate and screws asi

Komentáře k této Příručce

Žádné komentáře